Quality Control Technician II at Oceaneering International in Houston, TX

Job description

The quality control inspector will be required to comprehend specifications to determine testing/inspection procedures and equipment to be used. The candidate must be able to read dials or digital displays, compare results with specifications and record test/inspection data, confer with engineers, technicians and production personnel. Must be able to demonstrate the ability to perform dimensional checks and visual verifications of raw material, fasteners, fabricated and machined parts to acceptance criteria. Document and track non-conformance reports/material. Ability to work with minimal instruction and supervision. ESSENTIAL Responsible for performing inspections on materials, products, assemblies, sub-assemblies. Ability to read drawings, comprehend specifications and tolerances, read dial indicators and digital gages, compare results with specifications and record test data, confer with engineers, technicians and production personnel as necessary. Demonstrate advanced ability to perform dimensional checks and visual verifications of fabricated and machined parts to acceptance criteria. Uses measurement, test equipment and functional gages to determine if product meets all stated requirements. Validate the quality of machined and fabricated parts, and assemblies in terms of dimensional accuracy and visual verification according to acceptance criteria. Ability to review data supplied with material and parts to acceptance criteria, such as: dimensional reports, traceability reports and certificates of conformity. Liaise with suppliers as required to ensure good product, documentation and service quality is maintained. Understand and adheres to requirements of Gage Calibration, and Measurement System Analysis (MSA). Develop and maintain inspection plans per drawing requirements Interpret inspection results Assists more experienced technicians and professionals in technical tasks. Performs technical work tasks requiring moderate technical experience. Checks in with supervisors routinely, successfully completes task as requested, and begins to think independently about solutions for recurring problems in equipment handling. Elevates issue when beyond scope of position. Applies routine techniques and standards under moderate supervision. Shows initiative and enthusiasm to solidify foundational understanding of the work area, gain exposure to related work areas, and reach out for new skills Works under well-defined procedures and guidelines that require low levels of troubleshooting. Mentors or gives technical guidance to junior inspectors and technicians. Performs a range of tasks with autonomy and may act as a cross departmental technical lead. Applies a range of techniques and standards autonomously. Shall be utilized as subject matter expert in quality control techniques. Displays advanced professional communication and interpersonal skills when exchanging information with peers and supervisors. Often serves as a resource to others in the resolution of complex problems. Ensure all existing working procedures, practices and systems are followed. Ensure in date calibrated measuring equipment is used for performing inspection Must have a thorough understanding of advanced measurement techniques, and a basic understanding of Statistical Process Control Issues document, investigate, and track non conformances and inspection records in the following SmartSolve modules: Inspection Management, Non Conformance and Corrective Action/Preventive Action. Shall be capable of completing inspections, such as: FAT, SIT, FAI, In-Process, Final, Receiving inspections Work as a team member when performing or witnessing inspection and/or testing for internal and external customers, third parties, customer's inspectors, and engineering/manufacturing representative. Assist in developing and improving quality system procedures, work instructions, flow charts and associated process improvements. Uses safe material handling and preservation techniques,